Wax Based Castable Photopolymers

Series 200

EasyCast Series 200 is a Photopolymer Wax formulated & Developed in Canada. This Photopolymer wax has been tested with both DLP/LCD Platforms for consistency & performance. It has a unique Green colour. It is ideal for light to medium parts weighing from 10-25grams. 

15-25% Wax Content

Key Features –

  • Works with all investments
  • Tested with all precious metals
  • Our Suggested Burnout
  • DLP/LCD Compatibility
  • Over 20% Wax Content
  • No foul/strong odor
  • Premium Resinworks3D Castable Raw Materials used for Formulation
  • Prints sharp enough for fine jewellery
  • Strong tolerance for very high peeling speed making speed printing possible/faster.
  • Consistence in Printing with no wobble effect, no bad layer lines. (As per the tests done on DLP Printers)
  • Hard enough after printing making handling easy. Soft supports making support removal easy.
  • Low viscosity helps clean it easily in alcohol and also helps for speed printing.
  • Will print 0.40mm supports. Supporting pave beads is possible with small supports.
  • Will polymerize properly under a wide spectrum of different light intensity. (from a monochrome screen to a high power DLP projector)

Series 200

EasyCast Series 200 is a Photopolymer Wax formulated & Developed in Canada. This Photopolymer wax has been tested with both DLP/LCD Platforms for consistency & performance. It has a unique Green colour. It is ideal for light to medium parts weighing from 10-25grams. 

15-25% Wax Content

Key Features –

  • Works with all investments
  • Tested with all precious metals
  • Our Suggested Burnout
  • DLP/LCD Compatibility
  • Over 20% Wax Content
  • No foul/strong odor
  • Premium Resinworks3D Castable Raw Materials used for Formulation
  • Prints sharp enough for fine jewellery
  • Strong tolerance for very high peeling speed making speed printing possible/faster.
  • Consistence in Printing with no wobble effect, no bad layer lines. (As per the tests done on DLP Printers)
  • Hard enough after printing making handling easy. Soft supports making support removal easy.
  • Low viscosity helps clean it easily in alcohol and also helps for speed printing.
  • Will print 0.40mm supports. Supporting pave beads is possible with small supports.
  • Will polymerize properly under a wide spectrum of different light intensity. (from a monochrome screen to a high power DLP projector)

Suggested Burnout